Site Information

All prices are in USD

Installation Guide



BumpShox Installation Video

Step 1

Remove current license plate frame and save screws for STEP 2

Note: Not recommended for use on Volvos. The screws on Volvo license plate brackets, installed by the dealerships, are non-removable and are too short to accommodate BumpShox thickness.

Step 2

Re-install screws making sure BumpShox and license plate are securely attached to vehicle.

Do not over tighten screws as it may damage BumpShox.

Note:Included screws are size #14 x ¾ inch.

Disclaimer

Laws concerning the use of BumpShox products vary from state to state. Your state may restrict the use of novelty license plate frames. Manufacturer and retailer assume no liability for any use of this product in violation of any applicable law or regulation. Before installing BumpShox products check your state and local laws and regulations. BumpShox products are not designed to protect against vehicle damage in the event of an accident.